Resistant:
It is resistant to Oxidizing & Non-oxidizing Acids, & Chlorine Gas except Hydrofluoric Acid.
Resistant to temperature:
1000° C (Max.)Potassium Silicate Mortar is widely used for Acid Resistant Bricks & Tiles lining works as Bedding & Jointing Mortar for Tanks, Floor, Drain, Foundation.
Preparation of Mortar:
Preparation of Mortar generally consists of Solution & Powder. In order to obtain good working consistency, the average mixing ratio is 1 Pbw of Solution & 3 pbw of Powder. This ratio will slightly vary depending upon the temperature and working conditions. Prepare small batches of Mortar. Stirrer the Solution thoroughly before use. Place the Solution in a suitable mixing pan and add powder in it. Make sure that all the Mortar is used from the mixing pan before another batch is prepared.
Surface Preparation:
The cement plastered surface shall be slightly rough in line & level , dry & clean, free from dust, dirt, grease, oil etc., maintaining required slope etc. as no slope can be adjusted or altered in Acid proof lining works.
Setting/Curing:
Furomor Resin Mortar is a Self-hardening due to its chemical reaction which occurs when the Powder & Resin are mixed together.
An initial setting occurs in 6 to 8 hrs. at 30°C
Final Setting occurs in 24 to 48 hrs. at 30°C
Curing time: 7 days at 30oC
Please ensure that no water shall be spilled over the bricks lining works before it completely cured.
The cement plastered surface shall be slightly rough in line & level , dry & clean, free from dust, dirt, grease, oil etc., maintaining required slope etc. as no slope can be adjusted or altered in Acid proof lining works. Setting/Curing:
Furomor Resin Mortar is a Self-hardening due to its chemical reaction which occurs when the Powder & Resin are mixed together. An initial setting occurs in 6 to 8 hrs. at 30°CFinal Setting occurs in 24 to 48 hrs. at 30°C
Curing time: 7 days at 30oC
Please ensure that no water shall be spilled over the bricks lining works before it completely cured.
Potassium silimor™ mortar cond…. (Acid Resistant Mortar)
Acid Curing:
When the bedding & jointing mortar is different, after the bedding mortar is properly set, cure the joints for a minimum period of 72 hours with 20 to 25% HCL acid before applying the resin type mortar. After acid curing, wash the free acid in the joints with clean water & allow sufficient time for thorough drying. Resin mortar shall then be filled into the joints.
Storage Life
Solution : 24 Months at the temperature 30°C (+2°C) Solution : 24 Months at the temperature 30°C (+2°C)All two components are stored in cool and dry place under the roof until ready to use it original unopened (Sealed) containers.
Packing
Solution : 75 Kg. in M.S. Drum Powder : 50 Kg. in Plastic Bag.
Export Packing
( As per customer’s requirement) 